The gist of this leg design is to have the legs protrude through the tire. An example of how I wanted the legs to look like is here. This makes the legs splay out a little bit an aesthetic decision mostly. I set my miter sled to about a 2 1/2 deg. I cut the three legs apart on the table saw (be sure to support the taper to keep the leg from falling when free from the other piece). Later you will see the legs blackened to match our dark bookcases. ![]() The legs are turned out of a stick of Lyptus I had in my supplies. As for wood selection, this table is built out of leftovers excepting the top. I'm in the other 13.6%.īut I do have a lathe hanging around the shop, and I wanted to put a slight taper on the legs to give this chunky table slender legs a la 1950s furniture. I also understand that if someone does have a lathe, there is an 86.4% chance they are better at it than I am. Okay, I understand most people don't have a lathe. If you need to clean up any slop around the holes you just made, a razor blade works great. It produced a cleaner look that I was going for.Ĭhoose a hole saw that is a little bigger than the diameter of the legs you are going to use for the same reasons as above. I could have had the legs mounted to the outside of the tire, but I wanted them to appear as if they grew out of the tire. Halfway between the bead and tread on this line is where I put the leg holes. LEG HOLESĭraw the division lines out onto the sidewall. I clipped the flat washer so that it didn't dig into the sidewall and the problem was fixed. The round washers pulled on the sidewall of the tire and made an weird tension line. ![]() I suggest adding about 3/8" to this length to make it easier to get the floor supports on later. I cut the rod long enough to accomodate a nut, lock washer, and flat washer on each end. Insert the threaded rod through the holes. I didn't measure the distance from the inside of the bead, I placed them at the same valley on the bead all the way around.
0 Comments
Leave a Reply. |